Special Offer: Up to 33% off the new X-Carve Pro + $500 Gift Card

Hurry! Offer ends on 2/26

Call us: (312) 775-7009
Email: help@inventables.com
Mon - Fri: 9am - 5pm CST

Remake of "CNC Bit Holder"

9 likes
0 opens
0 copies
0 comments
William Burke

Project by

William Burke
Selden, NY

General Information

A small organizer to hold 1/8, 1/4 bits as well as collets. Added magnets to the sides to hold collet wrenches as well.

Like this project Open in Easel®
1

Added magnets after remaking the original design

Didn’t plan to add the magnets until later, so manually drilled the 5x holes and glued the magnets in using the following kit, but any set of mangets should do.