This is a waste board for X-Carve that has the following features.
There is some final fabrication required by the end user for this product to function. The inserts need to be installed. We have instructions that demonstrate how to do this. Please note the inserts go in from the back side.
Boards have provisions for adding additional cross members underneath for support. This is strongly recommended for the large version or it will sag over time.
If you purchased your X-Carve after 11/2/2021, you will need additional hardware to make this wasteboard compatible with your machine:
1 x 25281-02 Pre-Assembly T-Slot Nuts
1 x 26018-03 Extrusion Brackets
1 x 26049-04 Aluminum Extrusion – 20mm x 20mm x 958mm
The material is MDF. There may be small scratches, discoloration or scratches on the surface that do not affect performance.