Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

X/Y spacer

3 likes
2 opens
1 copy
0 comments
Keith Muskett

Project by

Keith Muskett

General Information

I use this to align the X-Y axis when starting Up the machine. I used 2.4mm GRP, with a 2mm end mill bit.
I place one either side, pull the gantry forward until it touches on both sides and then switch on the machine.
I added the red cord so it doesn’t get left on the CNC accidentally (again).

Like this project Open in Easel®