X-Carve Storage 12X24

7 likes
27 opens
17 copies
1 comment
Daniel Brashear

Project by

Daniel Brashear
Hubert, NC

General Information

This is my version of the storage from the one from Chip Clark published he made 3 different ones and I just combined them and used a single sheet of 3/4 HDPE. I used a 1/8" Solid Carbide 2 Flute Straight End Mill to do all the carving and it took about 12 hours to complete.

Like this project Open in Easel®
Daniel Brashear
I adjusted the size of the holes on the t handles after i completed my project I did not like how big they were on my version, I may remake it later on.
Daniel Brashear