Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

lord of the rings

79 likes
596 opens
231 copies
3 comments
chris parks

Project by

chris parks
de soto, MO

General Information

simple engraving that i used for cutting boards, after engraving i paint the lettering and sand all extra paint off when dryed

Like this project Open in Easel®
Don Yea
I noticed in the simulated cut the "R" and the "D" seem to have been missed by the cut path. Will it in fact cut or is this a bad sample.
Don Yea
chris parks
it shows that it cuts when i simulate from here so you should be good, try zooming in on the letters the cut path was small
chris parks
Joseph Hernandez
What font did you use?
Joseph Hernandez