Large Clamps for X-Carve

7 likes
0 opens
0 copies
66 downloads 0 comments
WorkinWoods

Project by

WorkinWoods

General Information

Hello everyone these are some clamps I made for the X-carve I hope you enjoy that help keep large pieces of work square

Like this project Open in Easel®
1

Setup and carve

open in easel and make sure all your settings are correct

Easel setup:

When you open this in easel please make sure and check all your settings as mine may not work for you

Safety Height: .150"
Step over: 40%
Feedrate: 30 in/min
Depth of cut per pass: .028"
Depth of total cut: .050"
material thickness: .25"
Material type: Red Oak
Bit Size: .125"
Bit Type: solid carbide 2 Flute straight flat end mill

I hope you enjoy this simple project if you have any questions just let me know