Geometric Corian Dishes

20 likes
101 opens
30 copies
4 comments
Ben Uyeda

Project by

Ben Uyeda
Boston, Massachusetts

General Information

i carved these dishes out of 1/2" corian

Like this project Open in Easel®
Conal
First, I obviously came from YouTube :), just here to find out the size of the bit (diameter) and the thickness of the material as I want to do a Mortise and Tennon joint in the project
Conal
Sophia Goehner
I have a question: I'm assuming you needed to carve both sides of the corian. How did you do this? Did you just turn the Corian over?
Sophia Goehner
Zach Kaplan
Hi Sophia if you want to do two sided carves you flip the material. In order to flip and center your work you need to have a way to align or register the work. If you make 2 holes that are symmetrical to the design and carve them into the wasteboard then use two pins to line it up on both sides.
Zach Kaplan
Zach Kaplan
Hi Conal, Looks like Ben used a 1/8" bit 1/2" Corian material. https://www.inventables.com/technologies/white-corian
Zach Kaplan