FCCB Logo Camp Table.nc

6 likes
18 opens
7 copies
2 comments

General Information

Table 2 of 10

Like this project Open in Easel®
Lyle Sutherland
very nice! i'm interested in setting up an xcarve to do similar work. do you mind if i ask what router and software you use?
Lyle Sutherland
Wayne Hesler-Mondore
Dewalt 611 and vcarve pro for the paths. I use coreldraw x8 for desiging prior to exporting to vcarve and path creation. This was carved using a 90* .50" bit. Took about 45 minutes.
Wayne Hesler-Mondore