Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

Carvey Spoil Board

4 likes
38 opens
7 copies
0 comments
Jim Tiffin Jr.

Project by

Jim Tiffin Jr.

General Information

A simple design to fit over the existing spoil board that’s fastened to the machine itself.

An 1/8" board, cut to 8″×12″, should allow you to do full depth cuts on different projects, without cutting into the existing spoil board. Install it when you need it. Remove it when you don’t!

Like this project Open in Easel®