Apple watch sport charging stand - stand part

11 likes
40 opens
13 copies
0 comments
joel yarmon

Project by

joel yarmon

General Information

The vertical stand the apple watch charger slots into. I used corian and a heat gun to bend it backwards to allow the watch band to ‘drape’ over the front of the stand as the watch face is held in place by the magnetic charger.

Like this project Open in Easel®
1

Carve out the base

with carvey!

2

Carve out the stand

with carvey!

3

Bend the stand using a plastic heat bender or heat gun

careful not to burn yourself

4

Sand the edges smooth

use 200 grit or higher