American Flag (Army) (8x5in Flag)

6 likes
0 opens
0 copies
4 comments
David Baird

Project by

David Baird
Toano, USA

General Information

A practice run with a new American Flag Graphic I picked up this weekend. It’s only 8" by 5.5"…but I can upscale it when I’m ready for a bigger carve. I did it on 1/2" Poplar with a 1/8" downward spiral bit. It took a little over an hour to carve. I used V-Carve Pro for my Software.

Like this project Open in Easel®
Lawrence Kelley
Why post and Not share ?? that's what this site was setup for, Hope you reconsider sharing for us Newbies :-) Nice work by the way
Lawrence Kelley
Steven Lewis
I really hope you share this. Very nicely done sir.
Steven Lewis
David Baird
I belong to a Facebook Group called “CNC For Beginners” and I bought this file from Mike Marshall. Part of my agreement with him was not to share the files, but point folks in his direction. I highly recommend reaching out to him via facebook.
David Baird
Steven Lewis
I understand and will do that. Thank you for the info David.
Steven Lewis